When using an ambient air vaporizer, you should know these basic common sense:
1. Pipeline: carefully read and understand the text marked on the gasifier furnace body, and operate and use the gasifier according to the prompts. Confirm that the liquid phase and gas phase outlets are connected to the corresponding pipes.
2. Water injection: To add water to the gasifier, clean distilled water should be added from the water injection place marked on the furnace body until the bottom of the furnace body overflows.
3. Power supply: If the furnace body of the gasifier does not have an electric control box, directly open the anti-riot cover on the furnace body, enter the three-phase four-wire power line from the wiring port on the furnace body, and connect the three-phase power supply to the wiring At A, B, and C marked on the board, N is the zero line.
4. Non-relevant persons should not adjust the temperature controller, relay, heating tube, etc. in the cover. These have been adjusted by the manufacturer before leaving the factory and cannot be adjusted at will.
5. Before using the vaporizer, please cover and tighten the opened explosion-proof compartment cover.
https://www.chinavaporizer.com/